Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Installation for Kirkland Homeowners
When your garage door is the problem, it’s the only problem. A door that sags, sticks, or leaves a gap at the bottom stops being the entry point you rely on and becomes a daily negotiation. That’s where we come in. Kirkland Garage Door Repair Co is a dedicated garage door specialist, not a general handyman outfit, and our technicians have up to 12 years of experience installing doors on Kirkland homes of every age and style. We work with LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor systems, so there’s no guesswork about what’s already on your house. For installation, we schedule a free measure and put the full price in writing before anything is ordered. Call (844) 725-1599. We answer 24/7.
What Our Garage Door Installation Service Includes
Every installation we handle is measured, ordered, and fitted for one specific opening. We don’t sell doors off a truck, and we don’t guess at sizes over the phone. Here’s what each type of job involves.
New Door Installation
A full new door installation means removing the old door and hardware, checking the opening and the spring system, and setting a new door on balanced springs. You need this when a door is beyond reasonable repair, when the panels are rusted through, or when the framing has shifted enough that a patch won’t hold. We measure the opening ourselves, confirm the spring is sized to the new door’s weight, and test the balance and safety reverse before we leave.
Single Car Door
A single car door covers a standard one-vehicle opening, usually around 8 to 9 feet wide. It’s the right call when you want one door for a one-car bay, or when you’re converting a double opening back to two separate doors. We size the springs to the lighter door weight so the opener isn’t working harder than it should.
Double Car Door
A double car door spans a two-vehicle opening and carries noticeably more weight than a single. Heavier doors need properly matched springs and a strong track setup, which is where a lot of cut-rate installs fall short. We check the header and the jamb before ordering, because a wide opening that isn’t square will show every flaw in a new door.
Custom Garage Door
Custom doors are built to a specific size, style, or window layout when a stock size won’t fit the opening or the look of the house. You’d go custom for an odd opening, a period home, or a design you want matched to the rest of the facade. We measure on site, talk through what’s buildable, and tell you plainly where a stock size would save you money instead.
Steel Doors
Steel doors are the most common choice for Kirkland homes because they hold up well and need little upkeep. They suit most single and double openings and come in a range of finishes and panel styles. We check the gauge and insulation of what we’re installing, since a thin door will dent and a poorly insulated one will rattle in a cold snap.
Wood Doors
Wood doors bring a warmth and character that steel and aluminum can’t match, and they suit Craftsman and older Kirkland homes especially well. They need more care over the years, so the finish and the grade of the wood matter more than the price tag. We fit them with springs matched to the actual weight of the wood, which runs heavier than most homeowners expect.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Installation
We work on Clopay systems and we know them well. Clopay makes a wide spread of door styles and insulation levels, and the difference between one model and another comes down to the steel gauge and how the panels are joined. That matters at install time, because a door that’s undersized for its springs will never run smoothly no matter how carefully it’s hung. We match the spring to the door, not the other way around.
Amarr and Wayne Dalton are two more we install regularly. Amarr builds solid steel doors with a good range of panel designs, and Wayne Dalton covers everything from basic steel to specialty styles. Each brand has its own hardware and its own quirks in the track and hinge layout, and knowing those quirks saves a lot of fiddling on install day. Whether you have a Clopay door, an Amarr, a Wayne Dalton, or any other make, we can help.
Signs You Need Garage Door Installation Right Now
Some problems are a repair. Others mean the door itself is finished. Here’s how to tell the difference.
- The door sags or hangs crooked. A door that sits unevenly in the opening usually points to a bent track, a failed spring, or a frame that’s shifted. If the framing has moved, a new door is often the cleaner answer than fighting the old one.
- Panels are rusted, cracked, or dented through. Surface dents are cosmetic. Rust that’s eaten into the steel or cracks that run across a panel weaken the whole door, and a door that’s lost its structure won’t balance properly.
- The door won’t stay closed or leaves a gap. Gaps at the bottom or sides let in water, cold air, and pests. If adjusting the track and hinges can’t close it, the door or the opening has moved and needs replacing.
- You’ve repaired the same problem more than once. Repeated spring failures, a door that keeps coming off its tracks, or an opener that strains every time it lifts all point to a door that’s too heavy or too worn for its hardware.
- You’re remodeling or selling. A new door changes how the front of a house reads, and it’s one of the few exterior updates that shows immediately from the street. If the old door is at the end of its life, it’s worth pricing now rather than mid-negotiation.
Our Garage Door Installation Process – Step by Step
- 1
Free measure and assessment. We come out, measure the opening, check the framing, the header, and the existing spring setup, and look at how the door needs to sit against the house. You get a written price for the door and the install before anything is ordered.
- 2
Door selection and ordering. We walk you through the options that fit your opening and your budget, including steel versus wood and single versus double. You choose the door. The lead time depends on the model, and we tell you what to expect up front.
- 3
Removal and prep. On install day we take down the old door and hardware and inspect the tracks, brackets, and framing. Any rot or loose framing gets dealt with before the new door goes up, because a new door on a bad frame will never sit right.
- 4
Installation and spring balancing. We hang the new door, set the springs to its actual weight, and adjust the tracks so the door runs true. Springs are under high tension and store a lot of force, which is exactly why this step belongs to a trained technician with the right winding bars and a proper safety setup, not a Saturday DIY project.
- 5
Testing and walkthrough. We run the door through full cycles, check the balance and the safety reverse, and confirm the opener is set correctly for the new door’s weight. Then we walk you through the operation and the care the door needs.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Installation Cost in Kirkland?
New door installation in Kirkland typically runs $700 – $2,200, depending on the size of the opening, the material, and whether the frame needs any work. A single car steel door sits toward the lower end. A double car door, a wood door, or a custom size pushes toward the higher end. Opener installation, if you’re replacing that at the same time, typically runs $250 – $550. These are estimated ranges, and the written estimate sets the final price.
What moves the number: door size, steel versus wood, insulation, window inserts, whether the framing is sound, and whether the opener needs replacing too. A door that’s easy to reach and sits on a square opening installs faster than one that needs framing repairs, and that shows up in the quote. To avoid overpaying, get the measure done in person rather than over the phone, ask what’s included in the install (haul-away, springs, tracks, opener adjustments), and insist on a written price before ordering. Our free estimate covers the measure, the door options that fit, and a line-by-line written price. The estimate is free.
Garage Door Installation Near Kirkland – Our Service Area
We install doors throughout Kirkland and the surrounding Eastside, including Kenmore, Redmond, Woodinville, Bothell, Lake Forest Park, Cottage Lake, Bellevue, Bothell East, Bothell West, Shoreline, and Mountlake Terrace. If you’re nearby and want a door measured and priced, we can schedule a visit. You can read more about our garage door installation work in Kenmore or our garage door installation work in Redmond, and if you’re closer to the water, our Kirkland Garage Door Repair Co page covers the full range of what we do.
Serving Kirkland, WA – Our Local Coverage Area
We serve Kirkland and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Installation in Kirkland
Garage door installation is the removal of an old door and the fitting of a new one, including the tracks, springs, and hardware, balanced and tested for your specific opening. It’s different from a repair, which fixes one part of a door that’s still sound. We measure the opening first so the door and its springs match the weight and size exactly.
A standard single or double door install usually takes a few hours on the day, once the door has arrived. The bigger variable is lead time on the door itself, which depends on the model and material you choose. We give you the expected timing when you order so you can plan around it.
New door installation in Kirkland typically runs $700 – $2,200, depending on size, material, and any framing work. Opener installation, if needed at the same time, typically runs $250 – $550. The written estimate sets the final price. Call (844) 725-1599 for an exact quote; estimates are free.
Yes, we work on Genie systems and know them well. We handle Genie doors and openers alongside LiftMaster, Chamberlain, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. Whether you have a Genie or any other make, we can help. Call (844) 725-1599 to book a measure.
Same-day service is available for repair work, and for installation we schedule a free measure and a written price. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
The warranty depends on the door and hardware you choose, and we go over it with you before you order. We confirm what the manufacturer covers and what our installation covers, in writing. Ask about it at the estimate so there are no surprises later.
Clear the garage floor and the area in front of the opening so the technicians have room to work. Move anything valuable away from the walls and ceiling where the tracks and springs will go. Have a parking plan for the day, since the opening will be unusable while the door is swapped. If you have questions ahead of the visit, call (844) 725-1599.
Schedule Your Garage Door Installation Service in Kirkland Today
If your door is at the end of its life, we’ll measure the opening, walk you through the door options that fit, and put a written price in front of you before anything is ordered. No pressure, no upselling a door you don’t need. Call (844) 725-1599. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The estimate is free and there’s no obligation.
Written by the team at Kirkland Garage Door Repair Co.