Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Redmond?
Most garage door repairs in Redmond run $150 – $600, and that range covers the jobs we’re called out for most: a snapped spring, a snapped cable, a door that’s jumped its tracks, or an opener that’s gone quiet. A full new door installation is a bigger number, typically $700 – $2,200 depending on size, material and whether the old door and hardware come out cleanly. Every figure on this page is a typical estimated range for the Redmond market, and the written estimate we give you sets the final price.
When your garage door is the problem, it’s the only problem. If you’re reading this because the door won’t close and the house isn’t secure, call (844) 725-1599. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday, and estimates are free.
Key Takeaways
- Typical repair range in Redmond: $150 – $600.
- Spring repair runs $180 – $340 for one spring; a matched pair is replaced together and costs about twice that.
- New door installation typically lands between $700 and $2,200.
- Small parts jobs (rollers, cables, tracks) often come in under $250.
- Estimates are free, and the written estimate is the price.
Garage Door Cost Breakdown (2026)
Here’s how the work breaks down by job type for Redmond homeowners in 2026. These are typical estimated ranges for the area, not a quote for your specific door.
| Service | Typical Estimated Range | What It Usually Covers |
|---|---|---|
| Garage door repair (general) | $150 – $600 | Diagnosis and fix for the common failures: springs, cables, rollers, tracks, hinges |
| Spring repair (one spring) | $180 – $340 | Replacing a single torsion or extension spring, with the door rebalanced after |
| Cable repair | $130 – $250 | Replacing a frayed or snapped lift cable and resetting drum tension |
| Opener repair | $120 – $320 | Fixing a dead motor, bad logic board, stripped gear, or remote/sensor fault |
| Opener installation | $250 – $550 | Supplying and fitting a new opener, including rail, brackets and safety sensors |
| Panel replacement | $250 – $500 | Swapping a dented or cracked section while keeping the rest of the door |
| Track realignment | $120 – $240 | Straightening and re-securing bent or knocked-out vertical and horizontal track |
| Roller replacement | $110 – $220 | New nylon or steel rollers and a quiet-door tune-up |
| New door installation | $700 – $2,200 | Removing the old door, fitting the new one, and setting springs and hardware |
What pushes a job toward the top of these ranges? Brand and hardware matter more than most people expect. A door built around Clopay or Amarr sections takes different panels and different trim than a Wayne Dalton setup, and an opener from LiftMaster, Chamberlain, Genie, Craftsman or Raynor each brings its own parts and quirks. We work on all of those systems and know them well, which cuts down on the guesswork that inflates a bill. Size plays a role too: a double-car door carries heavier springs and more panel area than a single, so both the part and the labor climb.
What keeps a job at the bottom of the range? Catching a problem early. A noisy roller or a slightly bent track is a small fix; ignore it for a season and the strain moves into the springs and the opener, and now you’re paying for two jobs instead of one.
What Affects Garage Door Pricing in Redmond
Redmond pricing isn’t a single number, and it shouldn’t be. Here’s what actually moves the estimate up or down.
- The door’s age and brand. Older doors built around legacy hardware can need parts that take more effort to match. Newer smart openers like LiftMaster and Chamberlain myQ units are usually faster to diagnose. We’re factory-familiar with eight major brands, so the brand itself rarely adds cost.
- One spring or a pair. Springs are rated for a cycle count and the two on a door wear together. If one has failed, the other is usually close behind, so replacing the pair is the common path. A single spring runs $180 – $340; a matched pair about twice that.
- Whether the door is off its tracks. A door that’s jumped the track or come down crooked is a safety call, not a tune-up. Track work runs $120 – $240, but a badly twisted door can need panels too, which pushes it toward the $500 – $600 end of the general repair range.
- How the door is used. In a lot of Redmond homes the garage is the front door: the kids come in through it, the recycling goes out through it, the car leaves from it several times a day. That cycle count wears springs and openers faster than a door that opens once a morning. If your garage is your main entrance, expect springs to reach the end of their life sooner.
- Weather and seasonal strain. The Puget Sound area swings between wet, mild winters and dry, warm summers, and that cycle works on wood frames, steel panels and lubricated moving parts alike. Doors that sit in direct afternoon sun on a south-facing driveway expand and contract more, which shows up as sticking panels and loosening hinges. Keeping the moving parts lubricated is the cheapest insurance against a stuck door.
- Opener condition. A simple remote or sensor fix is small money. A dead logic board or a stripped drive gear on an older unit can cost more to repair than the low end of a new opener install, and we’ll tell you honestly when that’s the case.
Repair or Replace? A Straight Answer
Repair is almost always the right call when the door structure is sound and a single component has failed: a spring, a cable, an opener, a roller. Those are the $110 – $340 jobs, and they get you back to normal fast.
Replacement starts to make sense in a narrower set of situations. If the door has multiple cracked or rusted panels, if the framing has rotted, or if the opener and springs are both at the end of their life on an old door, you’re stacking repairs that will keep coming. That’s when a new door installation in the $700 – $2,200 range can be the smarter spend. We’d rather show you the math than sell you a door, and we’ll walk through both paths before you commit.
If your door is failing right now and you need it working today, don’t wait on a decision. Call (844) 725-1599. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
How to Save on Garage Door Repair in Redmond
You don’t need a coupon to keep the bill down. You need to catch problems early and avoid the wrong fix.
- Get the free estimate in writing. A written estimate tells you exactly what’s being replaced and why, so you can compare like for like. Estimates are free, and the written estimate sets the final price.
- Fix the small stuff before it grows. A $110 – $220 roller replacement now is cheaper than a spring and opener job later. If the door is getting loud or sluggish, that’s the moment to call.
- Lubricate the moving parts. Hinges, rollers and tracks benefit from regular lubrication. It’s the one bit of garage door upkeep that’s safe to do yourself.
- Don’t DIY the springs. This is the one we’ll say plainly: torsion springs and cables are under serious tension, and a spring or cable that lets go can cause a severe injury. That’s exactly why spring and cable work belongs with a trained technician using the right tools and safety protocols, not a weekend project.
- Ask whether a repair beats a replace. Sometimes the honest answer saves you money, and sometimes it saves you from throwing good money at a failing door. We’ll give you the straight version.
One call covers the whole picture: springs, openers, panels and full installs. If you’d like a better sense of who you’re calling, see Kirkland Garage Door Repair Co, and call (844) 725-1599 for a free estimate.
When to Call for Same-Day Service
Some problems can wait for a scheduled visit. Others can’t. A door that won’t close leaves the house open, and a car trapped inside on a work morning is its own kind of emergency.
Call the same day if the door is stuck open or closed, if a spring has snapped (you’ll hear it), if the door is hanging crooked or off its track, or if the opener has died entirely. For the smaller stuff, a scheduled visit is fine and often easier on your day. Emergency service is a real part of what we do, not a marketing line, so a stuck door on a Sunday morning isn’t something you have to sit on until midweek.
For a broader look at the kinds of jobs we handle across the area, our garage door repair in Redmond page covers the common failures in more depth, and if you’re nearby, garage door repair in Kirkland and garage door repair in Bellevue walk through what we see in those neighborhoods too.
For the specific jobs that come up most:
- Garage door spring repair for the snapped-spring calls, which are the most common urgent repair.
- Garage door opener repair when the motor runs but the door doesn’t move, or the remotes stop responding.
- Garage door cable repair for frayed or snapped lift cables, which often go with a spring failure.
- Off-track garage door repair when the door has jumped the rail and won’t run straight.
- Garage door panel replacement for a dented or cracked section after an impact.
- New garage door installation if you’re weighing a full replacement.
- Garage door opener installation when the old unit has given up for good.
- Our garage door cost guide for a fuller picture of pricing across the region.
FAQs – Garage Door Cost in Redmond
How much does garage door repair cost in Redmond?
Most garage door repairs in Redmond run $150 – $600, with the exact number depending on which part failed. A single spring is typically $180 – $340, a cable $130 – $250, and a track realignment $120 – $240. Call (844) 725-1599 for an exact quote, since estimates are free.
How much does it cost to replace a garage door spring in Redmond?
Spring repair runs $180 – $340 for one spring. Because springs on a door wear as a pair, replacing both is the usual approach, and a matched pair costs about twice that range. We’ll tell you which path makes sense for your door. Call (844) 725-1599 and we’ll book you in.
Is it cheaper to repair or replace my garage door?
Repair is cheaper when a single component has failed and the door structure is sound, usually landing in the $110 – $340 range for springs, cables, rollers or tracks. Replacement, typically $700 – $2,200, makes more sense when multiple panels are damaged or the whole door is failing. Call (844) 725-1599 for a free estimate that lays out both options.
How much does a new garage door cost installed in Redmond?
A new door installed in Redmond typically runs $700 – $2,200, depending on size, material and the condition of the old door. Removal and disposal of the old door, new springs and new hardware are part of the job. Call (844) 725-1599 for a free estimate on your door.
Can you come today if my door won’t close?
Yes, a door that won’t close is a same-day priority. Emergency service is a core part of what we do, and a stuck or unsecured door gets priority over scheduled work. Call (844) 725-1599. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday, and estimates are free.
What does an opener repair or replacement cost in Redmond?
Opener repair runs $120 – $320, and a new opener installed runs $250 – $550. If the unit is older and the repair cost creeps toward the install range, we’ll tell you plainly that a new opener is the better spend. Call (844) 725-1599 for a free estimate.
Why Call a Dedicated Garage Door Specialist?
A general handyman with a toolkit can make a garage door worse. Springs carry stored tension, opener logic boards need real diagnosis, and a door that’s off its track has to be reset safely. Our technicians have up to 12 years of experience, and every one of them works on garage doors and nothing else. That focus is why we can tell the difference between a bad sensor and a failing logic board on a LiftMaster, or between a bent track and a worn roller on a Clopay door, without trial and error.
We repair, service openers, replace springs and install full doors. One call covers it, and the local pro is licensed and insured as their state requires. If something feels wrong with your door right now, call (844) 725-1599. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Redmond market as of 2026. Kirkland Garage Door Repair Co offers free estimates – call (844) 725-1599.
Written by the team at Kirkland Garage Door Repair Co.
What Our Customers Say
"Fixed the spring properly and the door works fine. He did leave the old spring and some hardware by the side of the house, and I had to text to ask about hauling it off. They came back for it, just took a couple of days."
- Shane Meyer"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
- Doug Novak"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Tim Mercer