Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does a Garage Door Cost in Kenmore?
Garage door work in Kenmore typically costs $150 – $600 for a repair, and most single fixes land near the middle of that range. A new door installation runs $700 – $2,200. Spring repair is $180 – $340 per spring, and opener repair is $120 – $320. Those are estimated ranges for the Kenmore market in 2026; the written estimate sets the final price. Call Kirkland Garage Door Repair Co at (844) 725-1599 for a free estimate – we answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Here’s the thing about garage door pricing most guides skip: the number you’re quoted depends less on the brand of your door than on what actually failed. A snapped torsion spring and a dead opener sound equally urgent, but they involve completely different parts, tools, and labor. We work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor systems, so we can usually tell you which category your problem falls into before anyone gets out of the truck. Our technicians have up to 12 years of experience with exactly these systems.
Key Takeaways
- Most repairs fall in the $150 – $600 range for Kenmore homeowners in 2026.
- Spring repair is priced per spring at $180 – $340 – a matched pair usually costs about twice that.
- New door installations run $700 – $2,200, depending on size, material, and insulation.
- Openers cost $120 – $320 to repair and $250 – $550 to install new.
- The written estimate is the price. Free estimates – call (844) 725-1599.
Garage Door Cost Breakdown (2026)
Here’s what the common jobs typically run in Kenmore this year. Every figure is an estimated range for the job as described, not a quote. The written estimate you get after we look at your door is what sets the final price.
| Service | Typical Estimated Range |
|---|---|
| Garage door repair (general) | $150 – $600 |
| Spring repair (per spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation (new) | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
What drives a ticket toward the top of a range? Usually one of three things. First, the number of parts involved – a single bad roller is cheap; two snapped cables plus the springs that caused them is not. Second, the age of the door. On older systems, one repair often reveals a second problem right behind it, like a worn bearing plate or a frayed cable you didn’t know was there. Third, whether the door is a standard single-car model or a wider double door with heavier panels and a bigger spring system.
Most Kenmore homeowners land in the $150 – $600 band on this table rather than the installation range below it. A door that just won’t lift, an opener that clicks but doesn’t move, or a panel that got tagged by a car all fall inside that window. If your door’s problem is specifically the opener, we cover both modern smart-home units and older legacy systems – the same call handles a LiftMaster myQ that lost its Wi-Fi connection and a Chamberlain that’s been dying a slow death since 2011.
What Affects Garage Door Pricing in Kenmore
Kenmore’s housing stock runs from hillside homes near the Sammamish River and the Burke-Gilman Trail corridor to mid-century ramblers closer to the lake. That mix shows up in the doors we work on. Here are the factors that move the estimate most.
- Door type and size. A single standard door has less panel, less track, and a lighter spring than a double door. Panel replacement costs $250 – $500 per panel, and a double door doubles the surface area.
- Spring configuration. Torsion springs (mounted above the header) and extension springs (running along the sides) are priced differently. We quote spring repair at $180 – $340 per spring, and a matched pair is usually replaced together, so a pair costs about twice that.
- Opener brand and age. Repair is $120 – $320. A common failure is a worn gear or a burned circuit board, and parts availability varies by brand. Modern LiftMaster and Chamberlain myQ units are well-supported; older legacy openers sometimes need a different approach, and we tell you which before we start.
- Whether a repair is a symptom of a bigger problem. A door that’s off its tracks often has a bent track or a damaged hinge. Track realignment runs $120 – $240, but if the underlying cause is a failed spring, that gets added.
- Installation scope. A new door install at $700 – $2,200 depends on material (steel, wood, aluminum), insulation, window inserts, and whether the existing opener and hardware can be reused.
- Access and layout. Low-clearance garages, doors that open onto a slope, and homes with a tight driveway all affect how the work is done. A hillside property in Kenmore with a steep approach isn’t the same job as a flat lot off Juanita Drive.
If you’re in Kenmore and your door is stuck, we can often diagnose it over the phone from the symptoms. A door that won’t open at all, a loud bang from the spring area, or a door that goes up crooked usually points to a specific part, and knowing that in advance keeps the estimate honest.
Is It Cheaper to Repair or Replace a Garage Door in Kenmore?
Repair is almost always cheaper for a single failed part: a spring repair at $180 – $340 will always beat a new door at $700 – $2,200. Replacement starts making sense when the door has structural damage, multiple failing components at once, or you’re upgrading insulation and hardware together. Here’s the practical way to think about it.
- One broken part, healthy door: repair. A spring, cable, roller, or opener fix closes the gap for a fraction of a new door.
- Two or more major failures at once: price out both. If cables, springs, and bottom panels are all worn, the repair bill can approach the low end of a new door install.
- Cosmetic damage only: panel replacement at $250 – $500 per panel is far cheaper than a full door. Most panel styles are still available for Clopay, Amarr, and Wayne Dalton doors.
- You want better insulation or a different look: replace. There’s no sensible repair that changes a door’s material.
If you’re not sure which side you’re on, call (844) 725-1599 and describe what you’re seeing. Estimates are free, and we’ll tell you straight which option fits your door.
How to Save on Garage Door Repair in Kenmore
The fastest way to save is to fix the problem before it spreads. Here are practical approaches we recommend to Kenmore homeowners.
- Get the estimate in writing before work starts. A written estimate sets the final price, so you know what you’re paying before a technician touches the door. That alone prevents most of the surprises on this list.
- Fix a bad roller or hinge early. Roller replacement at $110 – $220 is cheap compared to the track and cable damage that follows when a door keeps running on a worn roller.
- Replace springs in pairs. A matched pair shares the load. Replacing one spring while the other is near the end of its life usually means paying for a second service visit sooner than you’d like. We quote spring repair per spring at $180 – $340.
- Keep the door balanced. If the door feels heavy or slams down, get it checked. A door that’s out of balance strains the opener and shortens its life, and opener repair runs $120 – $320.
- Lubricate and inspect yearly. Rollers, hinges, and the opener rail benefit from routine attention. It’s the least expensive maintenance there is, and it prevents the majority of the calls we get.
- Ask about the full scope up front. When you have us out, we’ll look at the whole door, not just the broken part. If something else is about to fail, you’d rather know now than in a month.
Free estimates are the simplest savings there is. Call (844) 725-1599, tell us what’s going on, and we’ll give you a number before any work starts. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Should You DIY a Garage Door Repair in Kenmore?
No for springs and cables, yes for basic maintenance. Torsion springs store enormous energy, and a spring under load can cause serious injury if it’s released without the right tools and technique. We handle spring and cable work with proper protocols for exactly that reason. For a door that’s stuck, off its tracks, or making a loud bang, stop what you’re doing and call a professional.
You can safely handle the modest stuff: lubricating rollers and hinges, wiping down panels, and checking that the photo-eye sensors on the opener are clear and aligned. Beyond that, garage door systems involve high tension and heavy moving parts. We’d rather you called than risk a hand. Our technicians have seen every brand, every break, and every botched DIY fix, so if you’ve already tried something and it didn’t work, we can tell you what happened.
What Does a New Garage Door Installation Cost in Kenmore?
A new door installed in Kenmore typically runs $700 – $2,200. The range covers standard single and double doors in steel and aluminum, with wood and insulated options toward the top. The written estimate sets the final price and depends on the material, door size, window and hardware options, and whether your existing opener and springs can be reused.
If you’re shopping for a door, brand guidance matters more than most homeowners expect. Clopay and Amarr make some of the most common doors in this area, and each offers a range of panel and insulation options. Wayne Dalton doors show up frequently on older homes. We work with all three and can tell you which styles and configurations fit your opening and your budget without steering you toward a model you don’t need. Full installation runs from taking out the old door to balancing the new one and testing the opener – one company for the whole job.
It also makes sense to think about the opener at the same time. If your current opener is aging out, replacing it during a door install avoids a second service call. New opener installation runs $250 – $550 and we stock-compatible LiftMaster, Chamberlain, and Genie units based on what your door needs. Call (844) 725-1599 to start with a free estimate.
Why Choose Us for Garage Door Work in Kenmore?
We’re a dedicated garage door specialist, not a general home-services company. Every technician focuses solely on garage door systems, so when we quote a spring, an opener, or a full install, we’re not learning your hardware as we go. We work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor equipment, and we can tell the difference between a gear that’s stripped and a logic board that’s failed just from how the opener behaves.
That focus matters most when the door won’t move. Springs, openers, panels, full installs – one call covers it. Emergency garage door service is a real part of what we do, not a line in an ad, because a broken door doesn’t wait for business hours. When your garage door is the problem, it’s the only problem.
Our service range covers repair, opener repair, spring replacement, and complete new door installation, so a fix that starts as one job and reveals something bigger doesn’t mean a second contractor. Our technicians have up to 12 years of experience with these systems. All work is by trained, state-licensed professionals, and estimates are always free.
FAQs – Garage Door Cost in Kenmore
How much does garage door repair cost in Kenmore?
Garage door repair in Kenmore typically costs $150 – $600. The final price depends on which part failed and how many parts are involved. A single broken roller is at the low end; a spring plus cable plus track realignment lands higher. Call (844) 725-1599 for an exact quote – estimates are free.
How much does a garage door spring replacement cost in Kenmore?
Spring repair in Kenmore is $180 – $340 per spring. A matched pair is usually replaced together, so a pair costs about twice that. We quote per spring so there’s no ambiguity. Call (844) 725-1599 for an exact quote on your door.
Is it cheaper to repair or replace a garage door?
Repair is cheaper for a single failed part – $150 – $600 versus $700 – $2,200 for a new door. Replacement makes sense when a door has structural damage or several major components failing at once. Call (844) 725-1599 and we’ll tell you which option fits your door.
Can you come today for a garage door problem in Kenmore?
Yes, same-day service is often available. The phones are answered 24/7, and crews dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. Call (844) 725-1599 for a free estimate.
How much does a new garage door cost in Kenmore?
A new garage door installed in Kenmore runs $700 – $2,200. The range covers door size, material, insulation, and window options, plus whether your existing opener and springs can be reused. Call (844) 725-1599 and we’ll give you a written estimate – estimates are free.
Do you charge extra for same-day or emergency garage door service?
No. The price is set per job by the written estimate. That written number is the price, and it’s confirmed before any work starts. Call (844) 725-1599 to book a free estimate.
Get a Free Garage Door Estimate in Kenmore
If your door is stuck, making noise, or you’re planning a new installation, we’ll give you a number you can act on. Call (844) 725-1599 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Our technicians have up to 12 years of experience across eight major brands – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor.
Pricing reflects the Kenmore market as of 2026. Kirkland Garage Door Repair Co offers free estimates – call (844) 725-1599.
Written by the team at Kirkland Garage Door Repair Co.
What Our Customers Say
"Fixed the spring properly and the door works fine. He did leave the old spring and some hardware by the side of the house, and I had to text to ask about hauling it off. They came back for it, just took a couple of days."
- Shane Meyer"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
- Doug Novak"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Tim Mercer